Radial Needle Roller and Cage Assemblies - Changzhou YangFan Bearing Co.,ltd

The radial needle roller and cage assembly is a self-retaining rolling unit. The long space between two guidance face is easy for both guiding the needle roller accurately and choose reasonable position. The type is recommened to use when the shaft and housing bores are as raceway. The needle roller and cage assemblies provide rolling bearing arrangements with high accuracy within low radial section height.

1. 結構形式 /Structure Design

also manufactures split cage assemblies and inch system cage assemblies, such as WJ

2.The main type of cage are series M and series K. The cage is made of high quality carbon steel or low carbon alloy steel (15CrMo, 20CrMo) or plastic (nylon). After the cage is through and anti-friction Properties. The temperature of plastic cage should be 120 ℃ . The temperature 180 ℃ is allowable on condition that it is short time operating.

3. 滾針分組，在同一套組件中的滾針，其平均直徑的上下偏差為 2-3μm 。

3 . The needle rollers are sorted according to the deviation from the nominal diameter. The maximum diameter tolerance is 2~3μm.

4.軸和外殼座孔與組件配合處的技術要求 /Shaft and Housing Bore's Requiremerts

When the needle roller and cage assemblies are operated between axis and shell, the radial clearance is determined by the tolerance of axis and shell's raceway shaft and the housing bore must be designed as rolling bearing raceway. If the dimension of housing bore is G6, the shaft's tolerance is recommended as Table 2.

表 2 軸的公稱尺寸 /Table 2 Mounting Tolerance

In order to the radial needle roller bearing and cage assembly meet with the load capacity, the hardness of raceway should not less than 58~64HRC, the depth of hardened surface should be 0.6~1mm and roughness(Ra) mustn't over 0.2μm.